Xerox 8850 Service Manual page 177

16. (Figure 10): Continue to pull the Video Cable through the hole after releasing it from the
cable guides.
1
Disconnect the con-
nectors and remove
the Charge Scorotron
Harness
4
Remove the
3
spacer
Remove the bolt
Figure 10 Preparing to Remove the Image Module Assembly (View looking at the Rear
from the Right Side)
17. Lift out the Image Module Assembly / Pivot Bar combination.
8850/ 510DP
Replacement
1.
2.
3.
2
Unfasten the Video
Cable
03/2003
4-101
Reverse the removal steps for replacement of the Image Module Assembly.
Enter the diagnostics [0903] and input the LED rating designated on the new image mod-
ule, then press Enter.
Perform Electrostatic Series (ADJ 9.2).
Repairs and Adjustments
REP 9.20