Servicing The Fuses; Drive System Maintenance; Checking The Seat Belt; Checking The Rollover-Protection-System (Rops) Knobs - Toro Z Master Professional 6000 Series Operator's Manual

Figure 62
1. Positive battery post
2. Negative battery post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on right hand console
next to the seat (Figure
2. To replace the fuses, pull out on the fuse to
remove it.
3. Install a new fuse
Figure 63
1. Optional accesory—15A
2. Charge—25A
3. PTO—10A
3. Red (+) charger lead
4. Black (-) charger lead
63).
(Figure 63).
4. Main—25A
5. Console
Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Checking the
g000960
Rollover-Protection-System
(ROPS) Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep
the roll bar in the fully raised locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
Check that both the mounting hardware and the knobs
are in good working condition. Make sure that the
knobs are fully engaged with the ROPS in the raised
position. The upper hoop of the roll bar may need to
be pushed forward or pulled rearward to fully engage
both knobs (Figure
g008966
48
64).