Danfoss VLT FC 100 Series Programming Manual page 54

3. Parameter Description
3
3-11 Jog Speed [Hz]
Range:
*
Size related [0 - 1000 Hz]
3-13 Reference Site
Option:
*
Linked to Hand / Auto
[0]
[1] Remote
[2] Local
3-14 Preset Relative Reference
Range:
*
0% [-200 to +200 %]
54
Ref and Ref . Afterwards, the value is added to Ref
MAX MIN
0 / 1 / 2 [16], [17] or [18] for the corresponding digital inputs in parameter group 5.1* Digital Inputs.
Function:
The jog speed is a fixed output speed at which the frequency converter is running when the jog function is
activated.
See also par. 3-80.
Function:
Select which reference site to activate.
Use local reference when in Hand mode; or remote reference when in Auto mode.
Use remote reference in both Hand mode and Auto mode.
Use local reference in both Hand mode and Auto mode.
NB!
When set to Local [2], the frequency converter will start with this setting again following a
'power down'.
Function:
The actual reference, X, is increased or decreased with the percentage Y, set in par. 3-14. This results in the
actual reference Z. Actual reference (X) is the sum of the inputs selected in par.3-15,
Reference Source 2 Reference Source 3
3-16 , par. 3-17
MG.11.C5.02 - VLT ® is a registered Danfoss trademark
®
VLT HVAC Drive Programming Guide
. When using preset references, select Preset ref. bit
MIN
Reference Source 1
Control Word Source
, and par. 8-02
, par.
.