Danfoss VLT FC 100 Series Programming Manual page 35

®
VLT HVAC Drive Programming Guide
0-43 [Reset] Key on LCP
Option:
[0] Disabled
* Enabled
[1]
[2] Password
3.2.7. 0-5* Copy / Save
Copy parameter settings between set-ups and to/from the LCP.
0-50 LCP Copy
Option:
*
No copy
[0]
[1] All to LCP
[2] All from LCP
[3] Size indep. from LCP
This parameter cannot be adjusted while the motor is running.
0-51 Set-up Copy
Option:
*
No copy
[0]
[1] Copy to set-up 1
[2] Copy to set-up 2
[3] Copy to set-up 3
[4] Copy to set-up 4
[9] Copy to all
3.2.8. 0-6* Password
Define password access to menus.
0-60 Main Menu Password
Option:
*
-9999 - 9999
[100]
0-61 Access to Main Menu w/o Password
Option:
*
Full access
[0]
[1] Read only
[2] No access
[3] Bus: Read only
[4] Bus: No access
[5] All: Read only
Function:
No function
[Reset] Key is enabled
Avoid unauthorized resetting. If par. 0-43 is included in the My Personal Menu, then define the password in
0-65, Personal Menu Password
. Otherwise define the password in
Function:
No function
Copies all parameters in all set-ups from the frequency converter memory to the LCP memory. For service
purposes it is recommended to copy all parameters to the LCP after commissioning.
Copies all parameters in all set-ups from the LCP memory to the frequency converter memory.
Copies only the parameters that are independent of the motor size. The latter selection can be used to pro-
gramme several frequency converters with the same function without disturbing motor data which are already
set.
Function:
No function
Copies all parameters in the present edit set-up (defined in par. 0-11
Copies all parameters in the present edit set-up (defined in par. 0-11
Copies all parameters in the present edit set-up (defined in par. 0-11
Copies all parameters in the present edit set-up (defined in par. 0-11
Copies the parameters in the present set-up over to each of the set-ups 1 to 4.
Function:
Define the password for access to the Main Menu via the [Main Menu] key. If par. 0-61
w/o Password Full access
is set to [0], this parameter will be ignored.
Function:
Disables password defined in par. 0-60
Prevent unauthorized editing of Main Menu parameters.
Prevent unauthorized viewing and editing of Main Menu parameters.
Read only functions for parameters on fieldbus and/ or FC standard bus.
No access to parameters is allowed via fieldbus and/ or FC standard bus.
Read only function for parameters on LCP, fieldbus or FC standard bus.
MG.11.C5.02 - VLT ® is a registered Danfoss trademark
par. 0-60, Main Menu Password
Programming Set-up
Programming Set-up
Programming Set-up
Programming Set-up
Main Menu Password
.
3. Parameter Description
par.
.
) to Set-up 1.
) to Set-up 2.
) to Set-up 3.
) to Set-up 4.
Access to Main Menu
35
3