Danfoss VLT FC 100 Series Programming Manual page 12

2. How to Programme
• Reversing
• Set-up select lsb - Set-up select msb
• Stop command from serial communication
• Quick stop
2
• DC brake
[Off] stops the connected motor. The key can be selected as
If no external stop function is selected and the [Off] key is inactive the motor can be stopped by disconnecting the mains supply.
[Auto on] enables the frequency converter to be controlled via the control terminals and/or serial communication. When a start signal is applied on the
control terminals and/or the bus, the frequency converter will start. The key can be selected as
LCP
.
NB!
An active HAND-OFF-AUTO signal via the digital inputs has higher priority than the control keys [Hand on] [Auto on].
[Reset] is used for resetting the frequency converter after an alarm (trip). It can be selected as
LCP .
2.1.3. Quick Transfer of Parameter Settings between Multiple Frequency Converters
Once the set-up of a frequency converter is complete, we recommend
that you store the data in the LCP or on a PC via MCT 10 Set-up Software
Tool.
Data storage in LCP:
1. Go to par. 0-50
2. Press the [OK] key
3. Select "All to LCP"
4. Press the [OK] key
All parameter settings are now stored in the LCP indicated by the progress bar. When 100% is reached, press [OK].
NB!
Stop the motor before performing this operation.
You can now connect the LCP to another frequency converter and copy the parameter settings to this frequency converter as well.
12
LCP Copy
MG.11.C5.02 - VLT
Enable Disable
[1] or [0] via par. 0-41
Enable
Enable
® is a registered Danfoss trademark
®
VLT HVAC Drive Programming Guide
[Off] Key on LCP
.
Disable [Auto on] Key on
[1] or [0] via par. 0-42
Disable Reset Keys on
[1] or [0] via par. 0-43