Danfoss VLT FC 100 Series Programming Manual page 21

®
VLT HVAC Drive Programming Guide
2.1.11. Changing a Group of Numeric Data Values
If the chosen parameter represents a numeric data value, change the
chosen data value by means of the [
▲ ▼
the [ ] [ ] navigation keys. Use the [
the cursor horizontally.
▲ ▼
Use the [ ] [ ] navigation keys to change the data value. The up key
enlarges the data value, and the down key reduces the data value. Place
the cursor on the value you want to save and press [OK].
2.1.12. Changing a Data Value,Step-by-Step
Certain parameters can be changed step by step or infinitely varying. This applies to
Frequency (par. 1-23).
The parameters are changed both as a group of numeric data values and as numeric data values infinitely varying.
2.1.13. Read-out and Programming of Indexed Parameters
Parameters are indexed when placed in a rolling stack.
Par. 15-30 to 15-33 contain a fault log which can be read out. Choose a parameter, press [OK], and use the up/down navigation keys to scroll through
the value log.
Use par. 3-10 as another example:
Choose the parameter, press [OK], and use the up/down navigation keys keys to scroll through the indexed values. To change the parameter value,
select the indexed value and press [OK]. Change the value by using the up/down keys. Press [OK] to accept the new setting. Press [CANCEL] to abort.
Press [Back] to leave the parameter.
◀ ▶
] [ ] navigation keys as well as
◀ ▶
] [ ] navigation keys to move
MG.11.C5.02 - VLT ® is a registered Danfoss trademark
2. How to Programme
Motor Power (par. 1-20), Motor Voltage
2
(par. 1-22) and Motor
21