Danfoss VLT FC 100 Series Programming Manual page 111

®
VLT HVAC Drive Programming Guide
*
Off
[0]
[1] On
3.11.4. 10-2* COS Filters
Parameters for configuring COS filter settings.
10-20 COS Filter 1
Range:
*
FFFF [0 - FFFF]
10-21 COS Filter 2
Range:
*
FFFF [0 - FFFF]
10-22 COS Filter 3
Range:
*
FFFF [0 - FFFF]
10-23 COS Filter 4
Range:
*
FFFF [0 - FFFF]
3.11.5. 10-3* Parameter Access
Parameter group providing access to indexed parameters and defining programming set-up.
10-30 Array Index
Range:
*
0 [0 - 255]
10-31 Store Data Values
Option:
* Off
[0]
[1] Store edit setup
[2] Store all setups
Select the control source in Instance 21/71 and 20-70.
Enables control via analog/digital inputs.
enable control via the fieldbus.
Function:
Enter the value for COS Filter 1 to set up the filter mask for the Status Word. When operating in COS (Change-
Of-State), this function filters out bits in the Status Word that should not be sent if they change.
Function:
Enter the value for COS Filter 2, to set up the filter mask for the Main Actual Value. When operating in COS
(Change-Of-State), this function filters out bits in the Main Actual Value that should not be sent if they change.
Function:
Enter the value for COS Filter 3, to set up the filter mask for PCD 3. When operating in COS (Change-Of-State),
this function filters out bits in PCD 3 that should not be sent if they change.
Function:
Enter the value for COS Filter 4 to set up the filter mask for PCD 4. When operating in COS (Change-Of-State),
this function filters out bits in PCD 4 that should not be sent if they change.
Function:
View array parameters. This parameter is valid only when a DeviceNet fieldbus is installed.
Function:
Parameter values changed via DeviceNet are not automatically stored in non-volatile memory. Use this param-
eter to activate a function that stores parameter values in the EEPROM non-volatile memory, so changed
parameter values will be retained at power-down.
Deactivates the non-volatile storage function.
Stores all parameter values from the active set-up in the non-volatile memory. The selection returns to Off [0]
when all values have been stored.
store all parameter values for all set-ups in the non-volatile memory. The selection returns to
parameter values have been stored.
MG.11.C5.02 - VLT ® is a registered Danfoss trademark
3. Parameter Description
Off [0] when all
111
3