Danfoss VLT FC 100 Series Programming Manual page 195

®
VLT HVAC Drive Programming Guide
[0] Hour of day (24 coun-
ters used)
[1] Day of week (7 coun-
ters used)
[2] Day of month
counters used)
* Last 24 hours (24 coun-
[5]
ters used)
[6] Last 7 days (7 counters
used)
[7] Last 5 weeks (5 coun-
ters used)
NB!
The frequency converter has no back up of the clock function and the set date/time will reset to default (2000-01-01 00:00) after a
power down unless a Real Time Clock module with back up is installed. Consequently the logging will be stopped until date/time is
readjusted in par. 0-70,
set properly, e.g. after a power down.
23-51 Period Start
Range:
*
2000-01-01 00:00 [2000-01-01
00:00 - 2099-12-31 23:59 ]
NB!
When mounting an Analog I/O MCB109 option card, a battery back up of the date and time is included.
23-53 Energy Log
Range:
*
0-4294967295
[0]
The logging will start at the date programmed in
to Operating Hours (time where frequency converter is powered up).
(31
Set Date and Time
. In par. 0-79,
Function:
Set the date and time at which the Energy Log starts update of the counters. First data will be stored in counter
[00] and start at the time/date programmed in this parameter.
Date format will depend on setting in par. 0-71,
Format .
Function:
Array with a number of elements equal to the number of counters ([00]-[xx] below parameter number in dis-
play). Press OK and Step between elements by means of
Array elements:
MG.11.C5.02 - VLT ® is a registered Danfoss trademark
Period Start
, par. 23-51.In all cases the period split will refer
Clock Fault
, it is possible to program for a Warning in case clock not has been
Date Format , and time format on setting in par. 0-72,
▲ ▼
and buttons on the Local Control Panel.
3. Parameter Description
Time
195
3