Danfoss VLT FC 100 Series Programming Manual page 37

®
VLT HVAC Drive Programming Guide
0-72 Time Format
Option:
* 24 H
[0]
[1] 12 H
0-73 Time Zone Offset
Range:
*
0.00 [ -12.00 - 13.00]
0-74 DST/Summertime
Option:
*
OFF
[0]
[2] Manual
0-76 DST/Summertime Start
Range:
*
2000-01-01 00:00 [2000-01-01
00:00 – 2099-12-31 23:59 ]
0-77 DST/Summertime End
Range:
*
2000-01-01 00:00 [2000-01-01
00:00 – 2099-12-31 23:59 ]
0-79 Clock Fault
Option:
* Disabled
[0]
[1] Enabled
0-81 Working Days
Array with 7 elements [0]-[6] displayed below parameter number in display. Press OK and Step between elements by means of
LCP.
[0] No
* Yes
[1]
0-82 Additional Working Days
Array with 5 elements [0]-[4] displayed below parameter number in display. Press OK and Step between elements by means of
LCP.
Function:
Sets the time format to be used in the LCP.
Function:
Sets the time zone offset to UTC, this is needed for automatic DST adjustment.
Function:
Choose how Daylight Saving Time/Summertime should be handled. For manual DST/Summertime enter the start
date and end date in par. 0-76 and par. 0-77.
Function:
Sets the date and time when summertime/DST starts. The date is programmed in the format selected in par.
0-71.
Function:
Sets the date and time when summertime/DST ends. The date is programmed in the format selected in par.
0-71.
Function:
Enables or disables the clock warning, when the clock has not been set or has been reset due to a power-down
and no backup is installed.
Set for each weekday if it is a working day or a non-working day. First element of the array is Monday. The
working days are used for Timed Actions.
MG.11.C5.02 - VLT ® is a registered Danfoss trademark
3. Parameter Description
▲ ▼
and buttons on the
▲ ▼
and buttons on the
37
3