Danfoss VLT FC 100 Series Programming Manual page 104

3. Parameter Description
9-70 Edit Set-up
Option:
[0] Factory setup
*
Setup 1
[1]
[2] Setup 2
3
[3] Setup 3
[4] Setup 4
[9] Active setup
This parameter is unique to LCP and fieldbuses. See also par. 0-11
9-71 Save Data Values
Option:
* Off
[0]
[1] Store edit setup
[2] Store all set-ups
9-72 Drive Reset
Option:
*
No action
[0]
[1] Power-on reset
[3] Comm. option reset
9-80 Defined Parameters (1)
Array [116]
No LCP access
Read only
*
0 [0 - 115]
9-81 Defined Parameters (2)
Array [116]
No LCP access
Read only
*
0 [0 - 115]
104
Function:
Select the set-up to be edited.
Uses default data. This option can be used as a data source to return the other set-ups to a known state.
Edits Set-up 1.
Edits Set-up 2.
Edits Set-up 3.
Edits Set-up 4.
Follows the active set-up selected in par. 0-10.
Edit set-up
Function:
Parameter values changed via Profibus are not automatically stored in non-volatile memory. Use this parameter
to activate a function that stores parameter values in the EEPROM non-volatile memory, so changed parameter
values will be retained at power-down.
Deactivates the non-volatile storage function.
Stores all parameter values in the set-up selected in par. 9-70 in the non-volatile memory. The selection returns
to Off [0] when all values have been stored.
Stores all parameter values for all set-ups in the non-volatile memory. The selection returns to
parameter values have been stored.
Function:
Resets frequency converter upon power-up, as for power-cycle.
Resets the Profibus option only, useful after changing certain settings in parameter group 9-**, e.g. par. 9-18.
When reset, the frequency converter disappears from the fieldbus, which may cause a communication error
from the master.
This parameter displays a list of all the defined frequency converter parameters available for Profibus.
This parameter displays a list of all the defined frequency converter parameters available for Profibus.
MG.11.C5.02 - VLT ® is a registered Danfoss trademark
®
VLT HVAC Drive Programming Guide
.
Off
[0] when all