Danfoss VLT FC 100 Series Programming Manual page 177

®
VLT HVAC Drive Programming Guide
22-32 Low Speed [RPM]
Range:
0 RPM [0.0 - par. 4.13 (Motor High
Speed Limit)]
22-33 Low Speed [Hz]
Range:
*
0 Hz [0.0 - par. 4-14 (Motor High
Speed Limit)]
22-34 Low Speed Power [kW]
Range:
*
0 [0.0 - par. 22-38]
22-35 Low Speed Power [Hp]
Range:
*
0 [0.0 - Par. 22-39]
22-36 High Speed [RPM]
Range:
*
0 RPM [0.0 - par. 4-13 (Motor High
Speed Limit)]
22-37 High Speed [Hz]
Range:
*
0 Hz [0 - 1000 Hz]
22-38 High Speed Power [kW]
Range:
*
0 [Size dependent]
22-39 High Speed Power [Hp]
Range:
*
0 [0.0 - Max Motor Output]
Function:
Motor Speed Unit
To be used if par. 0-02,
Set used speed for the 50% level.
This function is used for storing values needed to tune No Flow Detection.
Function:
Motor Speed Unit
To be used if par. 0-02,
Set used speed for the 50% level.
The function is used for storing values needed to tune No Flow Detection.
Function:
To be used if par. 0-03, Regional Settings
selected).
Set power consumption at 50% speed level.
This function is used for storing values needed to tune No Flow Detection.
Function:
Regional Settings
To be used if par. 0-03,
selected).
Set power consumption at 50% speed level.
This function is used for storing values needed to tune No Flow Detection.
Function:
To be used if par. 0-02, Motor Speed Unit
Set used speed for the 85% level.
The function is used for storing values needed to tune No Flow Detection.
Function:
par. 0-02, Motor Speed Unit
To be used if
Set used speed for the 85% level.
The function is used for storing values needed to tune No Flow Detection.
Function:
To be used if par. 0-03, Regional Settings
selected).
Set power consumption at 85% speed level.
This function is used for storing values needed to tune No Flow Detection.
Function:
Regional Settings
To be used if par. 0-03,
selected).
Set power consumption at 85% speed level.
This function is used for storing values needed to tune No Flow Detection.
MG.11.C5.02 - VLT ® is a registered Danfoss trademark
3. Parameter Description
, has been set for RPM (parameter not visible if Hz selected).
, has been set for Hz (parameter not visible if RPM selected).
, has been set for International (parameter not visible if North America
, has been set for North America (parameter not visible if International
, has been set for RPM (parameter not visible if Hz selected).
has been set for Hz (parameter not visible if RPM selected).
, has been set for International (parameter not visible if North America
, has been set for North America (parameter not visible if International
3
177