YASKAWA FSDrive-MV1000 Parameter Manual page 47

H1-
Function
Setting
LOCAL/REMOTE Selection Open: REMOTE (parameter settings determine the source of the frequency
1
External Reference 1/2
2
Selection
3 Multi-Step Speed Reference 1
4 Multi-Step Speed Reference 2
5 Multi-Step Speed Reference 3
6 Jog Reference Selection
7 Accel/Decel Time Selection 1
8 Baseblock Command (N.O.)
9 Baseblock Command (N.C.)
A Accel/Decel Ramp Hold
B Drive Overheat Alarm (oH2)
Analog Terminal Input
C
Selection
E ASR Integral Reset
F Through Mode
10 Up Command
11 Down Command
12 Forward Jog
13 Reverse Jog
YASKAWA ELECTRIC EZZ010930 FSDrive-MV1000 Parameter Guide
H1 Contact Input Selections
All Modes
Reference 1 or 2 (b1-01, b1-02 or b1-15, b1-16))
Closed: LOCAL, digital operator is run and reference source
All Modes
Open: Run command and frequency reference source 1 (determined by b1-01 and
b1-02)
Closed: Frequency Reference Selection 2 (b1-15), Run Command Selection 2 (b1-
16)
All Modes
When contact input terminals are set to Multi-Step Speed References 1 through 3,
switching combinations of those terminals will create a multi-step speed sequence
using the frequency references set in d1-01 through d1-08.
All Modes
Closed: Jog frequency reference (d1-17) selected. Jog has priority over all other
reference sources.
All Modes
Used to switch between accel/decel time 1 (set in C1-01, C1-02) and accel/decel
time 2 (set in C1-03, C1-04).
The combination with H1-
switch between accel/decel time 3 and accel/decel time 4.
All Modes
Closed: No drive output
All Modes
Open: No drive output
All Modes
Open: Accel/decel is not held
Closed: The drive pauses during acceleration or deceleration and maintains the
output frequency.
All Modes
Closed: Closes when an oH2 alarm occurs
All Modes
Open: Function assigned by H3-14 is disabled.
Closed: Function assigned by H3-14 is enabled.
V/f OLV
Open: PI control
Closed: Integral reset
All Modes
Select this setting when using the terminal in a pass-through mode.
The terminal does not trigger a drive function but can be used as contact input for the
controller the drive is connected to.
All Modes
The drive accelerates when the Up command terminal closes, and decelerates when
the Down command closes. When both terminals are closed or both are open, the
drive holds the frequency reference. The Up and Down commands must always be
used in conjunction with one another.
All Modes
Closed: Runs forward at the Jog frequency d1-17.
All Modes
Closed: Runs reverse at the Jog frequency d1-17.
Description
=1A (Accel/Decel Time Selection) allows the drive to
CLV
1.3 Parameter Table
Reference
page
common_
common_
common
common
common_
common_
common_
common_
common_
common_
common
common_
common_
common_
common_
167
167
167
167
167
167
167
168
168
168
168
168
168
170
170
47