YASKAWA FSDrive-MV1000 Parameter Manual page 71

No.
Name
(Addr.)
U1-11 Output Terminal
(4AH) Status
U1-12
Drive Status
(4BH)
U1-13 Analog Input 1
(4EH) Input Voltage
U1-14 Analog Input 2
(4FH) Input Voltage
Output
U1-16
Frequency after
(53H)
Soft Starter
U1-17 DI-A3 Input
(58H) Status
U1-18 oPE Fault
(61H) Parameter
MEMOBUS/
U1-19
Modbus Error
(66H)
Code
YASKAWA ELECTRIC EZZ010930 FSDrive-MV1000 Parameter Guide
All Modes
Displays the output terminal status
U1 - 11=
0 0 0 0 0 0 0 0
All Modes
Verifies the drive operation status.
U1 - 12=
0 0 0 0 0 0 0 0
All Modes
Displays the voltage of analog input 1.
All Modes
Displays the input voltage of analog input 2.
All Modes
Displays output frequency with ramp time and S-curves. Units determined
by o1-03.
All Modes
Displays the reference value input from the DI-A3 option card.
Display will appear in hexadecimal as determined by the digital card input
selection in F3-01.
3FFFF: Set (1 bit) + sign (1 bit) + 16 bits
All Modes
Displays the parameter number that caused the oPE
write error) error.
All Modes
Displays the contents of a MEMOBUS/Modbus error.
U1 - 19=
0 0 0 0 0 0 0 0
Description
1: ON 0: OFF
Contact Output 1
Contact Output 2
Contact Output 3
Contact Output 4
Contact Output 5
Contact Output 6
Contact Output 7
Contact Output 8
1: ON 0: OFF
During run
During zero-speed
During REV
During fault reset
signal input
During speed agree
During ready
During alarm detection
During fault detection
or Err (EEPROM
1: ON 0: OFF
CRC Error
Data Length Error
Not used
(always OFF)
Parity Error
Overrun Error
Framing error
Time Out
Not used
(always OFF)
1.3 Parameter Table
Analog Output
Level
common_
No signal output
available
common_
No signal output
available
common_
10 V: 100%
common_
10 V: 100%
common_
10 V: Max
frequency
common_
No signal output
available
common_
No signal output
available
common_
No signal output
available
Unit Page
– –
– –
0.1% –
0.1% –
0.01 Hz –
– –
– –
– –
71