Faults - Agilent Technologies 6850 Series II User Information

Faults

Four lights on the injector indicate its status
During normal operation, the Ready light is on. If the injector is busy, the Run
light is on.
If another combination of lights are on, an error has occurred.
Use the following instructions to try to solve the problem before obtaining
Agilent service.
Figure 51. Injector status lights
No light is on
Released: March 2004
Probable causes
• The line voltage to the GC is off.
• The injector cable or connection to the GC is bad.
• Your GC requires service.
Suggested actions
1. Verify the injector is properly connected to the GC.
2. Check the power source for your GC.
3. Obtain Agilent service.
6850 Series II GC User Information
Align Mode light
Fault light
Run light
Ready light
Automatic Liquid Sampler and Injector
(Figure 51).
Faults
page 239 of 256