Agilent Technologies 6850 Series II User Information page 231

Filling the turret for use
1.
2.
3.
Removing the turret
1.
2.
3.
ESD cap
Caution Do not loosen the central mounting screw. This screw secures the motor hub in
place.
Released: March 2004
Load all samples to be run into the turret. Make sure that you place them
in the turret positions that correspond to the sequence (Control Module or
ChemStation/Cerity Chemical control) or Work List (Cerity control). The
vial positions are labeled.
Load clean, empty waste bottles into the appropriate waste locations.
Always load a bottle in the Waste C location.
Load your solvent bottles into the solvent locations as needed.
Remove all vials from the turret.
Remove the syringe and the needle support foot.
Remove the two plastic screws in the ESD cap, and remove the cap from
the motor hub.
6850 Series II GC User Information
Automatic Liquid Sampler and Injector
The 6850 automatic liquid sampler
Remove screws
page 231 of 256