Agilent Technologies 6850 Series II User Information page 96

FAULT 233
Possible causes:
FAULT 234
Possible cause:
FAULT 237
Possible cause:
FAULT 238
Possible causes:
FAULT 239
FAULT 240
Possible cause:
FAULT 241
Possible cause:
Released: March 2004
Aux temp too hot
To clear the message, turn off all the heated zones, then turn the instrument
off and on again.
Defective aux heater
Defective main board
The aux zone's temperature is higher than the maximum allowable
temperature (aux type maximum temperature plus 25 xb°C). Power is disabled
to the small heated zones and the oven.
Aux temp sensor
Defective aux temp sensor
The auxiliary thermal zone's temperature reading is lower than expected,
which indicates a shorted sensor. Power will be turned off for the zone.
No line interrupt
Defective main board
The electronics on the main board are not functioning correctly. Power is shut
off to the oven and other heated zones. The GC will not be ready.
Bad line interrupts
Excessive noise in the power supplied to the instrument
Defective main board
The main board detected an excessive amount of noise in the power supplied
to the GC. Power is shut off to the oven and other heated zones. The GC will
not be ready.
Turn the GC off and then on again. If the problem was caused by noise in the
power supply, the GC will operate normally again. If the error persists, the
main board is defective.
No mux ADC response
Mux ADC offset value
Defective main board
The multiplexer, which processes the GC's electronic signals, is not
functioning. Most likely, the multiplexer's circuitry is defective. Power is shut
off to the oven and other heated zones. The GC will not be ready.
Invalid line sense
Defective main board
The line sense circuitry on the main board is not measuring the line power
correctly. Since it is indicating that the power supply is not within acceptable
limits, the power to the heated zones is disabled.
6850 Series II GC User Information
Messages
Fault messages
page 96 of 256