Nortel Meridian 1 Replacement Manual page 60

Page 60 of 362 Replacing equipment
553-3001-520 Standard 16.00 April 2000
<a>
<cr>
7 At the Install Menu, select the following options in sequence
<e>
<y>
<y>
<a>
<cr>
8 Remove the diskette from the IOP/CMDU or CMDU.
9 Select the following options to quit:
<q>
<y>
<a>
Note: The system will reboot. Wait for the "INI" and "DONE"
messages to display before continuing. It will take at least 70 seconds
between the "DONE" and "INI" messages.
After the system initialization has finished (INI messages are no longer
displayed on the system terminal), check for dial tone on a telephone set.
10 Following a successful dial tone test, perform the following basic sanity
tests:
a Make sure calls can be placed
b Check for error messages, line noise, chatter, or other problems.
Track sources and resolve problems as necessary.
To place the system back in the redundant (normal) mode with automatic
switchover capability. Perform the following five steps in uninterrupted
sequence on the inactive Core (the Core with the replaced CP card):
11 Press and hold down the MAN RST button on the CP card of the inactive
Core.
12 While holding down the MAN RST button, set the NORM/MAINT
switch on the same CP card to NORM.
to continue with ROM upgrade
to return to the Install Menu
to install CP-BOOTROM
to start installation
to continue installation
to continue with ROM upgrade
to return to the Install Menu
to quit
to confirm quit
to reboot the system.