Nortel Meridian 1 Replacement Manual page 185

4 Reconnect power to the top cap:
a Connect the ribbon cable connector to connector J2 on the
backplane. Line up the alignment tab on the connector and snap on
the pin headers to position the connector correctly (see Figure 23).
Figure 23
Aligning the thermostat harness connector
Alignment tab
Side view of connectors
b Connect the orange connector to the module power harness.
c Replace the rear cover on the module.
5 Reconnect the system monitor to the circuit breaker system:
a Push the system monitor into position and tighten the screws.
b Replace the grill on the pedestal.
6 Tag defective equipment with a description of the problem and package
it for return to a repair center.
Replacing equipment
on backplane
connector
Page 185 of 362
Key on cable
connector
553-5885
Hardware replacement