Nortel Meridian 1 Replacement Manual page 272
Hardware replacement
Hide thumbs
Also See for Meridian 1:
- Manual (1121 pages) ,
- Planning and installation manual (612 pages) ,
- Planning, installation and operating instructions (556 pages)
Table of Contents
Advertisement
Page 272 of 362
553-3001-520 Standard 16.00 April 2000
Replacing equipment
Installing equipment
1
Set the ENB/DIS switch to DIS on the replacement card.
2
Set option switches on the replacement card the same as on the card you
removed. If there is a vintage change, be sure to check Circuit Card:
Installation and Testing (553-3001-211) for any differences.
3
Insert the replacement card into the vacated slot and hook the locking
devices.
4
Connect cables to the replacement card.
5
Set the ENB/DIS switch to ENB on the replacement card.
6
Software enable each port on the card:
ENL TTY x
— When the process is complete, you will receive a system response.
— If there is a problem, an IOD system message is generated and the
red LED lights on the faceplate of the card.
— If there is no problem, exit LD 37:
****
7
Tag defective equipment with a description of the problem and package
it for return to a repair center.
Advertisement
Table of Contents
