Nortel Meridian 1 Replacement Manual page 341
Hardware replacement
Hide thumbs
Also See for Meridian 1:
- Manual (1121 pages) ,
- Planning and installation manual (612 pages) ,
- Planning, installation and operating instructions (556 pages)
Table of Contents
Advertisement
Replacing an NT7D10 PDU with an
NT7D67CB PDU
Use this procedure to replace an NT7D10 PDU with an NT7D67CB PDU in
DC-powered systems.
Note 1: The NT7D67CB PDU replaces the NT7D10 PDU. However,
both PDUs can be used in a system.
Note 2: Conduit is not required with the NT7D67CB PDU but can be
used.
Before you begin this procedure, prepare for the installation:
•
Additional wire may be required (see Step 1).
•
An electric drill, fitted with a .234-in. metal bit must be available.
•
A Rear Mount Conduit Kit (NT7D0902) must be available.
Module covers are not hinged; do not let go of the cover. Lift the cover
away from the module and set it out of your work area.
WARNING
Page 341 of 362
Hardware replacement
Advertisement
Table of Contents
