Nortel Meridian 1 Replacement Manual page 188

Page 188 of 362
553-3001-520 Standard 16.00 April 2000
Replacing equipment
3 Remove the air probe harness:
a Remove the screw that secures the perforated panel at the LED
mounting bracket.
b Slide the perforated panel slightly to the left (looking at it from the
rear of the column). Lift the panel and turn it over.
c Pull the air probe out of the clip holder (see Figure 26).
Figure 26
Air probe harness
Air probe
d Clip cable ties that secure the air probe wiring. Be careful not to
damage other wiring (such as the thermostat harness).
e Remove the orange connector from the right-angle bracket at the top
of the module. Simultaneously push the four small snaps (two on
each side) on the connector to release it from the bracket (see
Figure 27).
Figure 27
Connector for the air probe harness
To orange connector
Front
Air probe
wiring
Perforated
panel
(bottom)
553-5887
Push here
Orange connector
Push here
553-5888