Ntnd02 Misc/Sdi/Peripheral Signaling Card - Nortel Meridian 1 Replacement Manual

NTND02 Misc/SDI/Peripheral Signaling Card

Installing equipment
1 Install the ROM card on the replacement ICM card:
a Plug the ROM card into the pin connector.
b Install the screw and washer at each corner of the ROM card.
2 Insert the replacement ICM card into the vacated slot and hook the
locking devices.
The system will sysload. Check system messages in the X11 System
Messages Guide (553-3001-411).
Tag defective equipment with a description of the problem and package
it for return to a repair center.
Use this procedure to replace a misc/SDI/peripheral signaling (MSPS) card.
See the X11 Administration (553-3001-311) for a description of all
maintenance commands and the X11 System Messages Guide (553-3001-411)
for interpreting system messages.
Module covers are not hinged; do not let go of the cover. Lift the cover
away from the module and set it out of your work area.
Call processing will stop when the MSPS card is removed. An
initialization will occur when the new card is installed.
Replacing equipment
WARNING
CAUTION
Page 237 of 362
Hardware replacement