Nortel Meridian 1 Replacement Manual page 37

2 Remove the battery pack from the MSPS card:
a) Disconnect the wire from the battery pack assembly to the
connector on the MSPS card. Unplug the clip connector wired
to the battery pack.
b) On the back side of the MSPS card, remove the three screws
that secure the battery pack.
Installing equipment
1 Install the battery pack on the MSPS card:
a) Position the battery pack on the component side of the MSPS
card; install the screws for the battery pack from the back of
the card.
b) On the component side of the MSPS card, plug in the clip
connector wired to the battery pack. Make sure the connector
key is centered on J2 (see Figure 8).
Note: The battery will not be fully charged until 24 hours after
installation in a powered system.
Figure 8
Connector for the battery pack assembly
Replacing equipment
Battery
pack
Page 37 of 362
Clip
J2
connector
553-5442
Hardware replacement