Nortel Meridian 1 Replacement Manual page 45
Hardware replacement
Hide thumbs
Also See for Meridian 1:
- Manual (1121 pages) ,
- Planning and installation manual (612 pages) ,
- Planning, installation and operating instructions (556 pages)
Table of Contents
Advertisement
8
Slide the replacement card cage into position in the UEM leaving
approximately 3" clearance between the card cage and the backplane.
9
Reconnect cables, plugs, and wires from the UEM to the backplane:
a
Connect all cables from the interior of the I/O assembly to the
backplane.
b
Position the backplane access plate. Replace the screws.
c
Connect all plugs, wires, and cables to the backplane.
Installing equipment
1
Slide the replacement card cage into position in the UEM taking care not
to pinch the cables.
2
Install the three mounting screws that secure the front of the card cage to
the bottom of the UEM assembly.
3
Replace the front cover plates on both sides of the card cage.
4
Install the mounting screws at the back of the card cage.
5
Reconnect cables, plugs, and wires from the UEM to the backplane:
a
Connect all cables from the interior of the I/O assembly to the
backplane.
b
Connect all plugs, wires, and cables to the backplane.
c
Position the power plug access plate. Replace the screws.
Replacing equipment
Hardware replacement
Page 45 of 362
Advertisement
Table of Contents
