Nortel Meridian 1 Replacement Manual page 182

Page 182 of 362
553-3001-520 Standard 16.00 April 2000
Replacing equipment
4 Remove the thermostat harness:
Note: The column LED and LED wiring are part of the thermostat
harness.
a Pull the LED ring away from the LED mounting bracket (see
Figure 19). You may need to loosen it with a standard screwdriver.
Figure 19
Mounting for the column LED
b Push the LED back completely out of the collar on the LED
mounting bracket.
c Remove the LED ring by pulling it forward over the LED. Keep the
ring handy; you will use it with the replacement equipment.
d Remove the screw that secures the perforated panel at the LED
mounting bracket.
e Slide the perforated panel slightly to the left (looking at it from the
rear of the column). Lift the panel and turn it over.
f Clip all cable ties that secure the thermostat harness. Be careful not
to damage other wiring (such as the air probe harness).
g Pull the LED through the rubber grommet at the front of the
perforated panel.
LED
Collar
ring
(back)
Perforated panel
screw
Mounting
bracket
Collar
(front)
LED
553-3048