Running the PD1000A Control Software Demonstration Mode
S-Parameter Demo
Just as in running a full device characterization test, the system prompts you to
calibrate the Network Analyzer. For the demo, you do not need to calibrate the
ENA. Click the Continue button. The following graphics show the S-Parameter
demonstration displays. A sample result (*.mdm) format file is also produced.
Figure 45 On State S-Parameter Demo Display
88
1 To run the PD1000A S-Parameter demonstrations, select either the On
State or the Off State S-Parameter test tab.
2 Check the Demo Mode check box on the display screen.
3 Click the
button at the bottom of the screen.
Keysight PD1000A Power Device Measurement System Startup Guide
S-Parameter Demo