Set Initial Test Settings - Keysight PD1000A Startup Manual

Power device measurement system for advanced modeling

Hide thumbs Also See for PD1000A:

Table of Contents

IV and CV Device Characterization

7 Click the X icon to close the Hardware Configuration dialog.

Figure 22 Close the Hardware Configuration dialog to apply settings

Set Initial Test Settings

For detailed information about each test, refer to the PD1000A Control Software

Help File. (Click the help (?) icon in the upper right corner of the display.)

Figure 23 Select Initial Test Settings

1 Demo Mode: Check this box if you want to run the IV/CV Demonstration. This

2 DUT Type: Choose FET or IGBT from the drop-down list. (If you are using a

3 Set the Temperature Control Mode, depending on whether you have the InTEST

provides a simple current/voltage plot and result (*.mdm) file. See "IV and CV

Demo" on page 86.

B1505A power device analyzer, you must also select the test type: IV, CV, or

Gate Diode.)

Thermal Platform (HP289-PM, available separately, contact

www.inTESTthermal.com)

– Fully Remote: If you have the InTEST Thermal Platform, enter the

temperature(s) you want tested in the temperature field, separated by

semicolons (;). The software automatically heats the test chamber and

triggers the measurements when each temperature is reached.

Keysight PD1000A Power Device Measurement System Startup Guide

Running the IV and CV Tests

Table of Contents