Table of Contents
Advertisement
IV and CV Device Characterization
Setup and Configure the Keysight B1506A and EasyEXPERT
The following B1506A and EasyEXPERT setup and configuration needs to be only
once.
1 Turn the B1506A on. For specified accuracy, allow the B1506A to warm up for
2 Check the EasyEXPERT software version and update if the version is less than
3 When the B1506A is first powered on, it opens with the Easy Test Navigator
Set B1506A Environment Variables
This section uses the ConfigurationTool.exe file that you downloaded to a
memory stick. See "Download Setup and Configuration Files" on page 19.
1 Insert the memory stick into the B1506A front panel. Run the PD1000A
Figure 8
2 Click the Setup B150x button to run the Environment Variables configuration.
34
Important: Always use the latest firmware in the B1506A Analyzer.
Firmware updates are available at:
www.keysight.com/find/B1506A.
EasyEXPERT Software version 6.1.1742.9630 (or later) must be
installed in the B1506A. Software updates are available at:
www.keysight.com/find/EasyEXPERT.
a minimum of one hour before running any IV and CV tests.
6.1.1742.9630. After updating the EasyEXPERT software, reboot the B1506A.
software. Close the Easy Test Navigator by right clicking on its icon (
selecting (X) Close Window.
ConfigurationTool.exe.
PD1000A Configuration Tool
This utility needs to be run one time only.
Keysight PD1000A Power Device Measurement System Startup Guide
IV and CV Test Requirements
) and
Advertisement
Table of Contents
