Table of Contents
Advertisement
On State and Off State S-Parameter Characterization
Test Requirements
On State (biased) and Off State (zero biased) S-Parameter tests require the
following instruments:
E5080A ENA Network Analyzer Setup
* Refer to the PD1000A Test Fixture User Guide for installation and use information.
64
– E5080A ENA Vector Network Analyzer
– Keysight B2902A Precision Source/Measure Unit (used for On State tests
only but should remain in circuit for Off State tests.)
– PD1000A Option -SPK includes the following:
-- Quantity 2, PD1000A Bias T Networks
-- Three DUT Test Fixtures
--Test Fixture for 3-terminal TO-220 style devices
--Test Fixture for 3-terminal TO-247 style devices
--Test Fixture for Surface Mount (SMD) devices.
-- Quantity 2, Type N Male – SMA Female Adapter (Keysight pn
5062-6682)
-- Quantity 2, SMA connector cables (7", Keysight pn 5062-6682)
-- Quantity 8, Banana plug to Banana plug cables (4 red and 4 black, for
connecting the B2902A SMU to Bias T)
S-Parameter tests are performed at room temperature and thus
do not require the B1506A or the InTEST Thermal Platform.
However, you do need to specify the room temperature in the
Hardware Setup.
Do not apply voltage/current over the maximum limit of the Bias T
networks, the socket module or adapter. Use a socket module or
adapter rated for the temperature range of your test.
Prior to running the On State and Off State S-Parameter tests, you
must install an executable file on the E5080A ENA. This needs to
be done only one time for the ENA. See "Download Setup and
Configuration Files" on page 19 for instructions on creating a
memory stick with the required files.
*
:
Keysight PD1000A Power Device Measurement System Startup Guide
Test Requirements
Advertisement
Table of Contents
