Create The Iv And Cv And Cv-Iv Switching Setups In The Library - Keysight PD1000A Startup Manual

IV and CV Test Requirements

Create the IV and CV and CV-IV Switching Setups in the Library

This section uses the UHC Selector Input Selection.xkd file that you downloaded
to a memory stick. See "Download Setup and Configuration Files" on page 19.
1 For the B1506A, insert the memory stick into the front panel.
2 In the tabs at the left, select Application Test.
3 Then select Library > Import.... Show All Files.
4 Locate and import the UHC Selector Input Selection.xtd file.
5 Click the UHC Selector Input Selection icon.
Figure 15 Configure the IV to CV and CV to IV Switch Parameters
Setup the IV to CV Switch
1 Specify the HVSMU slot. (See Figure 15 above and refer to the Modules tab in
2 For the SMU Slot Number, enter 0 (zero).
3 Click the Save tab (right side of screen) to save it to My Favorite.
4 Right click the icon and rename it as IV to CV. IMPORTANT: use this exact file
Keysight PD1000A Power Device Measurement System Startup Guide
"Configure EasyEXPERT"
name as shown, including the spaces between words and capitalization.
on page 37. Typically, the HVSMU slot is Slot 7.)
IV and CV Device Characterization
41