Table of Contents
Advertisement
Running the IV and CV Tests
11 Input – HVSMU: Enter the name of the HVSMU used for input (for example,
12 Input – SMU: Enter the name of SMU used for SMU input (for example,
13 Input – Gate SMU: Enter the Gate SMU name:
Temperature Settings:
1 Hot Plate VISA Address: From the appendix, "Configure the InTEST Thermal
2 Settling Temperature Timeout (in minutes): The maximum time that you allow for
3 Temperature Range (Radius) (°C): The acceptable tolerance of the measured
4 Transistor Temperature Delay (S): The time to wait (in seconds) after the target
5 Set the Hot Plate to room temperature after measurement: Check the box if you
6 Maximum Hot Plate Temperature Allowed: Specify the maximum temperature for
Keysight PD1000A Power Device Measurement System Startup Guide
-- For the H71 option, use the UHCU named: SMUn:UHC1500.
SMU3:HV).
– Use with the B150xA option H21 (20 A) only.
– Leave this field blank for options H51 and H71.
– Look up the module name from the HVSMU input field in the Module
Selector tab of the Configuration dialog in EasyEXPERT.
EasyEXPERT"
on page 37.)
SMU3:MF).
– Use with the B150xA option H21 (20 A) only.
– Leave this field blank for options H51 and H71.
– Look up the module name from the HVSMU input field in the Module
Selector tab of the Configuration dialog in EasyEXPERT.
EasyEXPERT"
on page 37.)
– For the B1506A: always use SMU2:MC.
– For the B1505A:
-- Identify the SMU that connects to the gate of the DUT.
-- Look up the SMU/module name from the Modules tab of the
Configuration dialog in EasyEXPERT.
page 37.)
Platform Controller," starting on page 95.
the Hot Plate to reach the specified temperature.
temperature.
temperature is reached.
want the Hot Plate reset to ~23 ° C after temperature measurements
complete. Leave the box unchecked to retain the existing temperature.
the Hot Plate ( ° C).
IV and CV Device Characterization
(See "Configure
(See "Configure
(See "Configure EasyEXPERT"
on
51
Advertisement
Table of Contents
