Install S-Parameter Control Software License - Keysight PD1000A Startup Manual

Additional instructions for using these files are presented at different parts of this
guide.

Install S-Parameter Control Software License

All aspects of the PD1000A Control Software can be installed and used for 30
days without a license. However, after 30 days a permanent software license is
required to continue running On State and Off State S-Parameter tests. For
software and licensing information, go to: www.keysight/com/find/PD1000A.
Other than the initial trial software license, there is one available license for the
PD1000A Control Software for S-Parameter tests:
20
– TO_Fixture_In.xkt — E5080A Calibration Kit file for S-Parameter
measurements. For instructions, see PD1000A Power Device Test Fixtures
for S-Parameter Measurements - Operating Guide, available at:
https://literature.cdn.keysight.com/litweb/pdf/PD1000-90005.pdf?id=29
59097
– TO_Fixture_Out.xkt — E5080A Calibration Kit file for S-Parameter
measurements. For instructions, see PD1000A Power Device Test Fixtures
for S-Parameter Measurements - Operating Guide, available at:
https://literature.cdn.keysight.com/litweb/pdf/PD1000-90005.pdf?id=29
59097
Ignore this section if you are not going to make On State or Off
State S-Parameter measurements. Proceed directly to "Step 3.
Setup and Run Device Characterization Tests" on page 24
– PD1000A-1FP -- A perpetual fixed license. This license enables the software
only on the host controller PC the license is originally assigned to; without
a time limit.
You must install the Keysight License Manager software on your
host controller PC (if it was not previously installed by other
Keysight software).
1 Once you purchase the PD1000A S-Parameter Test software license, you
can choose to receive a printed copy of an Entitlement Certificate, an email
with the certificate, or both.
2 On the host controller PC where you have installed and plan to run the
PD1000A software (you must be logged on with Administrator privileges),
log onto Keysight's Licensing website at:
www.keysight.com/find/softwaremanager. Note, you must register if you
don't have an account.
Step 2: Install System Software on Host PC
www.keysight.com/find/licensemanager.
Keysight PD1000A Power Device Measurement System Startup Guide