Table of Contents
Advertisement
Configure the InTEST Thermal Platform Controller
Figure 52 Remote GPIB Interface Connected and Verified
98
4 Click the Test Connection button. The word, "Verified" should appear to the
right of the button.
5 Click OK. In a moment, the InTEST Thermal Platform controller should
appear in the list of instruments.
6 Note the VISA Address in the Connection Strings table (right half of the display).
This is the address that you to need to enter in the PD1000A IV and CV
Hardware Configuration.
Configure the E5810B Gateway for the InTEST Controller
Keysight PD1000A Power Device Measurement System Startup Guide
Advertisement
Table of Contents
