Iv And Cv Demo - Keysight PD1000A Startup Manual

Power device measurement system for advanced modeling

Hide thumbs Also See for PD1000A:

Table of Contents

Running the PD1000A Control Software Demonstration Mode

IV and CV Demo

Although the demo runs without any test equipment attached to the host PC,

you must provide a slot address for each SMU in the Hardware Configuration

dialog. Refer to "B150xA Settings:" on page 50 for more information. Here is a

typical Hardware Configuration dialog (you can use these addresses if

necessary):

Figure 43 Sample Hardware Configuration Dialog

Keysight PD1000A Power Device Measurement System Startup Guide

IV and CV Demo

Table of Contents