Keysight PD1000A Startup Manual page 11

Keysight PD1000A Power Device Measurement System for Advanced Modeling
Dedicated host controller PC
running PD1000A Control software
LAN Switch
(not supplied
with PD1000A)
PD1000A Option GTW
E5810B GPIB/LAN
InTEST HP289-PM High Temperature
Thermal Platform (order separately
from inTEST (www.intestthermal.com)
Figure 1 Complete PD1000A Power Device Measurement System for Advanced Modeling Hardware Overview
PD1000A Option 201
Port 1
E5080A ENA Vector
Network Analyzer
LAN Cables
(not supplied
with PD1000A)
PD1000A Option 301
B2902A Precision Source
Measure Unit (SMU)
GPIB Cable
PD1000A Options 101 through 106
B1506A Power Device Analyzer/Curve Tracer
Port 2
CH2 Rear panel to PD1000A
Drain/Collector Bias T
PD1000A
Bias T Network
Ch1 Front panel to PD1000A
Gate/Base Bias T
Part of PD1000A Option SPK, S-Parameter
Includes Test Fixtures for TO-220, TO-247, or SMD
Devices, calibration standards, Bias Ts, cables, etc.
PD1000A System Software
Components
Required PD1000A system software
includes the following:
– PD1000A Control Software. This
software controls the test
equipment to make the
characterization
measurements.
– PEMG Power Electronics Model
Generator (Integrated Circuit
Characterization and Analysis).
This software provides
semiconductor device
characterization and modeling.
– Keysight Advanced Design
System (ADS)
All system software is available on
Keysight websites:
PD1000A
Test Fixture for
www.keysight.com/find/PD1000A
TO-220, TO-247,
Control Software)
or SMD Devices
www.keysight.com/find/eda
modeling and simulation)
Measurement Accessory Kit.
(for
(for