Power Electronic Model Generator (Pemg) Software; Before Running The Pemg Software - Keysight PD1000A Startup Manual

Power device measurement system for advanced modeling

Hide thumbs Also See for PD1000A:

Table of Contents

Power Electronics Model Generator (PEMG) Software

Power Electronic Model Generator (PEMG) Software

Prior to running the PEMG software, you must have Keysight's Advanced Design

System (ADS) Simulation software installed on your system. For detailed

information, click here:

System (ADS).

1 To open the Environment Variables window, type "Environment Variables" in the

Figure 42 Setting the ADS Environment Variable

2 Click the New... button.

3 Enter "ADS_DIR" as the Variable name.

4 Enter the path name where the Keysight ADS was installed as the Variable

5 Click OK twice to exit the Environment Variables setup dialog.

www.keysight.com/find/eda

You must also set an environment variable named "ADS_DIR" at the

Windows System Environment level with the path to the ADS

installation. Note: your ADS installation path may be different

than that shown below.

Windows Search Field. In the Advanced tab, select the Environment Variables

button.

value.

Keysight PD1000A Power Device Measurement System Startup Guide

then click Advanced Design

Table of Contents