Table of Contents
Advertisement
IV and CV Test Requirements
Configure EasyEXPERT
1 Select Tools > System > Configuration.... This opens the EasyEXPERT
2 Select the Modules tab.
Figure 12 Modules Tab of Configuration Editor for the B1506A Options H51 and
3 Verify that the modules listed match the modules actually installed in your
Keysight PD1000A Power Device Measurement System Startup Guide
Configuration Editor screen.
H71. (Option H21 is different.)
power device analyzer and the status of every SMU is "PASS".
Write down or make a screen capture of the Configuration window
so that you can easily enter SMU name information for the
following steps (through "Enable Temperature Regulation Loop" on
page 45).
The following steps (through "Enable Temperature Regulation
Loop" on page 45) are required for B1506A Options H51 and H71
only. They are not required for Option H21.
IV and CV Device Characterization
37
Advertisement
Table of Contents
