Trim Rod Assembly - BRP Evinrude E-Tec Series Service Manual

Remove the rod from the vise. Use a small screw-
driver to carefully pry the scraper out of the end
cap. Discard the scraper.
Use a suitable tool to remove the inner quad-ring
and the outer O-ring. Discard the quad-ring and
O-ring.

Trim Rod Assembly

Lubricate and install a new quad-ring and scraper
in the end cap. Install the scraper with the bevel
facing out. Lubricate and install a new O-ring on
the outside of the end cap.
2
1. Bevel
2. O-ring
SERVICING – THREE PISTON SYSTEM
Lubricate and install a new O-ring and two new
back-up rings on the trim rod piston. Place one
back-up ring on each side of the O-ring. Position
the open end of the back-up rings 180° apart.
41843
1. O-ring
2. Back-up rings
Using Hydraulic
P/N 983213, clamp the rod tightly in a vise and
lubricate the cap and rod. Slide the end cap onto
the rod and install thrust pad. Torque thrust pad
84 to 108 in. lbs. (9.5 to 12 N·m).
41844
1. Thrust pad
1
41845
TRIM AND TILT
2 1
41847
Cylinder Rod Holder,
41848
383
1
13