INSTALLATION AND PREDELIVERY
BOAT RIGGING
BOAT RIGGING
Remote Controls
Control Selection
WARNING
The remote control used must have start-
in-gear prevention. This feature can pre-
vent injuries resulting from unexpected
boat movement when the outboard starts.
Remote control styles and applications are
described in the Evinrude/Johnson Genuine Parts
and Accessories Catalog. Plan the installation of
all remote controls carefully. Read the outboard's
Operator's Guide and the remote control's installa-
tion instructions prior to installation.
The remote control and wiring harness used must
have the following features:
Start-in-gear prevention
•
Emergency stop / key switch
•
Shift stroke must measure 1.125 to 1.330 in.
•
(28.6 to 33.8 mm) between NEUTRAL and
FORWARD
Throttle stroke must PUSH for open
•
All wiring must be compatible with Modular Wir-
•
ing System (MWS) components
3
1. Emergency stop clip
2. Safety lanyard
3. Key switch with emergency stop feature
34
Additional remote control information:
Power trim/tilt switch(s) can be integral to the
•
remote control for outboards with power tilt and
trim.
Side-mount controls require a neutral lock fea-
•
ture.
Single-outboard binnacle remote controls are
•
offered with or without an integrated key switch.
Dual-outboard binnacle remote controls require
•
separate key switches and a single emergency
stop switch.
Dual-outboard key switches with emergency stop
switch
Always install and recommend use of an
emergency stop/key switch. Doing so will
reduce the risk of personal injury or death
should the operator fall away from the con-
trols or out of the boat.
002817
WARNING
DRC40118