BRP Evinrude E-Tec Series Service Manual page 66

INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING
Connect the purple wire from the CANbus Ignition
Harness to the CANbus Network Harness. This
connection supplies power to the network when
the keyswitch is on.
1. CANbus power supply connector
Secure all cables to anchor points with tie-straps.
1. Anchor points
If a CANbus water pressure gauge is used, install
Water Pressure Transducer Kit, P/N 5006214, in
the cylinder block.
1. Water pressure transducer
64
install the transducer lead in the engine wiring har-
ness connector and secure in bracket.
1
1
1. Water pressure transducer lead
2. Engine harness connector
005269
If a CANbus oil level gauge is used, an optional
CANbus oil level sender must be installed in the
oil tank. Connect the oil level sensor harness to
the boat CANbus network.
Use the Evinrude Diagnostics Software program
1
to activate CANbus control functions in the EMM.
From the Settings screen, select Engine Options.
005270
Engine Options Screen
1. Trim gauge calibration
2. Multi-engine setup
3. Water pressure gauge setup
1
004961
2
004962
1
2
3
005136