BRP Evinrude E-Tec Series Service Manual page 173

Terminal Installation
Align terminal with connector housing and push
terminal with seal into connector housing until
seated.
2
1. Latch
2. Terminal with seal
†
Packard Connectors
Always use the appropriate meter
IMPORTANT:
test probes and adapters when testing compo-
nents fitted with these terminals.
Disconnect
Lift latch(s). Remove connector.
Connect
Confirm the seal is in place. Push connector onto
housing until latched.
Terminal Removal
A tab on the back side of the terminal engages a
shoulder in the connector housing to hold the ter-
minal in place. The terminal is removed by push-
ing wire and terminal through connector housing.
1
Insert a thin wire, such as a paper clip, into the
connector above the terminal to release tab.
002456
TYPICAL
Terminal Tool
DSC02124
ELECTRICAL AND IGNITION
CONNECTOR SERVICING
DRC5940
6
DRC5941
171