BRP Evinrude E-Tec Series Service Manual page 340

GEARCASE
ASSEMBLY
Install new seals in driveshaft bearing housing.
Refer to Driveshaft Bearing Housing on p. 326.
Using Driveshaft Seal Protector, P/N 318674,
slide the driveshaft bearing housing onto the
driveshaft.
1. Seal protector
Install washers on the driveshaft bearing housing
screws. Apply Gasket Sealing Compound to the
threads of the screws. Install screws and torque to
120 to 144 in. lbs. (13.6 to 16.3 N·m).
1
1. Driveshaft bearing housing screws
338
"O," "L,"
Refer to DRIVESHAFT SHIMMING on p. 332
before proceeding.
Position the driveshaft thrust bearing, thrust
washer, and shim(s) (selected earlier) on the
driveshaft, exactly in order shown.
1
3
2
COA3130
1. Thrust bearing
2. Thrust washer
3. Shim(s)
Install new seals in driveshaft bearing housing.
Refer to Driveshaft Bearing Housing on p. 326.
Using Driveshaft Seal Protector, P/N 318674,
slide the driveshaft bearing housing onto the
driveshaft.
1
005425
1. Seal protector
Move shift rod to position clutch dog as far forward
as possible. Be sure excess grease is removed
from the pinion bearing.
"M" T G
AND YPE EARCASES
1
COA3168
1
COA3130