BRP Evinrude E-Tec Series Service Manual page 320

GEARCASE
DISASSEMBLY
"O," "L," "M" T
AND
Position the shift rod to move the clutch dog as far
forward as possible. This will assist in the removal
of the pinion nut.
Loosen the pinion nut from the bottom of the
driveshaft using Driveshaft
P/N 311875, Pinion Nut Holder, P/N 334455, and
Wrench Retainer, P/N 341438. Pad the handle of
holder to prevent damage to gearcase.
1
1. Holding socket
2. Pinion holder
3. Retainer
Remove the four driveshaft bearing housing
screws with washers.
1
1. Driveshaft bearing housing screws
318
G
YPE EARCASES
Holding Socket,
COA3153
The bearing housing, shims, thrust bearing, and
thrust washer will come out with the driveshaft.
4
1. Bearing housing
2. Shims
3. Thrust bearing
4. Thrust washer
Reach inside the gearcase and remove the pinion
gear and pinion nut.
3
2
42229
If driveshaft cannot be removed, refer to (Special)
Driveshaft Removal Procedures
1
1
2
3
COA3558
COA3159
.
on p. 319