BRP Evinrude E-Tec Series Service Manual page 56

INSTALLATION AND PREDELIVERY
OUTBOARD INSTALLATION
Transom Drilling Locations
All models use the standard ABYC 4-Bolt mount-
ing pattern.
Transom drill fixture, P/N 434367 or P/N 385368,
may be used as a guide for correct hole place-
ment. If drill fixture is unavailable, refer to Drilling
and Hardware Diagrams on p. 55 for measure-
ments.
Position drill fixture on top of transom or bracket
and align indicator points with centerline.
Transom drill fixture P/N 434367 (heavy duty)
The indicators are affected by the squareness of
the top edge of the transom. If either side of the
fixture must be raised more than ¼ in. (6 mm)
above the transom's top surface to make both
indicators align, the transom must be modified.
54
IMPORTANT:
edge of the transom is straight. Position the drill
fixture based on measurements aligning it to the
bottom of the hull.
IMPORTANT:
of transom surface above the top mounting bolts.
Make sure that the proposed mounting hole loca-
tions will provide adequate clearance for mounting
bolts and washers.
Check the inside area of the transom for obstruc-
tions prior to drilling mounting holes.
Check transom height(s) at centerlines prior to
drilling any mounting holes.
Drill four ½ in. (13 mm) mounting holes in the
appropriate locations.
IMPORTANT:
perpendicular to transom surface.
24496
DO NOT assume that the top
Maintain at least 1.75 in. (45 mm)
Be sure to drill the required holes