BRP Evinrude E-Tec Series Service Manual page 379

Remove the three Pozidriv screws securing the
reservoir to cylinder body. Remove reservoir.
Remove the reservoir O-ring from the cylinder
body. Check machined surfaces for nicks and
scratches.
1
1. O-ring
Use a 6 mm hex wrench to remove the plug from
the cylinder body. Inspect the O-ring and the filter.
Replace, if necessary.
SERVICING – THREE PISTON SYSTEM
Remove the four screws securing motor to pump
manifold assembly.
41753
Remove the wire shield from the pump manifold.
Remove the motor and inspect the motor O-ring
and the O-ring on the cable connector.
41759
Remove and inspect the coupler. Remove the fil-
ter screen from the pump manifold. Check the
machined surfaces on the manifold for nicks and
scratches. The pump manifold is not serviceable.
Do not remove the pump or any control valves
from the manifold. Clean the screen with a mild
41787
TRIM AND TILT
41760
22878
13
377