Components; Oil Tank; Oil Injection Pump - BRP Evinrude E-Tec Series Service Manual

COMPONENTS

The oiling system consists of the following compo-
nents:

Oil tank

•
Oil injection pump and manifold assembly
•
Oil pressure sensor
•
Electrical circuit
•
LOW OIL (SystemCheck) and NO OIL warning
•
signals (EMM LED's, SystemCheck and I-Com-
mand)
Cylinder and crankcase
•
Rear oil manifold assembly
•
Oil recirculation system
•
Oil Tank
The oil tank must be properly positioned and the
oil supply must be properly monitored. Refer to
installation instructions provided with oil tank and
Oiling System Set-Up on p. 43 for additional
information.
Oil Tank Components
Tank, 1.8 or 3.0 gallon capacity
•
Oil pickup assembly (included with tank)
•
Fill cap (included with tank)
•
Mounting bracket and hardware
•
Protective cover (1.8 gallon tank only)
•
Hose clamp
•
Hose plug
•
1.8 Gallon Oil Tank Kit
Oil Pick-up Components
Pickup hose
•
Sending unit, LOW OIL warning, and oil pickup
•
Filter
•
Primer bulb and supply hose
•
1. Pickup hose
2. Sending unit
3. Filter
4. Primer bulb and oil supply hose

Oil Injection Pump

The oil injection pump is an electric (55 V) actua-
tor style pump. It draws oil from the oil tank
through the oil supply hose [25 ft. (7.6 m) maxi-
mum] and supplies pressurized oil to the oil mani-
fold. The EMM supplies 55 V and controls
activation of the pump.
2
1
1. Oil injection pump
2. Oil manifold
The oil manifold distributes the oil supplied by the
44839B
oil injection pump. A pressure-sensor monitors the
oil injection pressure. Refer to Oil Injection Pump
Diagram on p. 203
OILING SYSTEM
COMPONENTS
4
1
3
2
42785
8
005371
201