Trim Rod Removal - BRP Evinrude E-Tec Series Service Manual

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

TRIM AND TILT

SERVICING – THREE PISTON SYSTEM

Trim Rod Removal

Unscrew trim cylinder end caps using Trim Cylin-

der End Cap Remover/Installer, P/N 436710, or

Universal Spanner Wrench, P/N 912084, and a

breaker bar. Small pins must be used in the span-

Slide the caps to the end of the rods. Drain the

fluid from the top of the pistons.

Slowly pull each piston out with a rag wrapped

around the rod and the top of the cylinder.

Drain the remaining fluid from the cylinders.

Inspect both bores of the trim cylinders for exces-

sive scoring. If one or both trim bores are scored

or damaged, the hydraulic assembly must be

Remove and discard both back-up rings and the

O-ring from each trim rod piston.

P/N 983213, clamp the rod tightly in a vise.

Remove the thrust pad from the trim rod, then

remove the end cap.

Table of Contents