BRP Evinrude E-Tec Series Service Manual page 349

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

Remove the forward gear bearing only if it needs

to be replaced. If removal of the bearing is neces-

sary, use Large Puller Jaws, P/N 432129, and

Puller Bridge, P/N 432127, with an appropriate

base. Leave the rollers in to allow for good contact

with the puller jaws.

If removed, install a new forward gear bearing.

Apply Needle Bearing grease to 25 new rollers.

Install the rollers in the bearing.

Using Bearing Installation Tool, P/N 339778,

install the bearing, lettered side facing tool.

Install the thrust bearing on the forward gear.

Place the bearing housing on the forward gear.

Install 0.030 in. (0.7 mm) of shims and the thrust

bearing in the flange. Install the thrust bearing on

the forward gear.

COUNTER ROTATION

Chapters

Table of Contents