Pinion Gear Bearing - BRP Evinrude E-Tec Series Service Manual

Align holes in the clutch dog with slot in the pro-
peller shaft. Install the clutch dog on the shaft with
"PROP END" facing rear of the shaft.
The clutch dog is not symmetri-
IMPORTANT:
cal. If installed backward, it will not fully engage
and will immediately damage itself and the gears.
1. "PROP END"
Slide the propeller shaft onto the shift shaft, align
the hole in the shaft with the hole in the clutch
dog, install the pin and then, a new clutch dog
retaining spring. Position three coils over each
end of the pin, MAKING SURE NONE OF THE
COILS OVERLAP OR ARE LOOSE.
1. Retaining spring
BEARING AND SEAL INSTALLATION

Pinion Gear Bearing

Assemble the following components of Pinion
Bearing Remover and Installer, P/N 391257, as
shown:
1
COB7581
"S" Type Gearcases
1. 1/4-20 X 1/2 in. Hex head screw
2. 1 in. O.D. Flat washer
3. Spacer, P/N 341437
4. Plate, P/N 391260
5. Rod, P/N 326582
6. Installer/Remover, P/N 326574
7. 1/4-20 X 1 1/4 in. Hex head screw
1
COB3101
"O," "L," and "M" Type Gearcases
1. 1/4-20 X 1/2 in. Hex head screw
2. 1 in. O.D. Flat washer
3. Spacer; P/N 350932 "M" and "XP", P/N 326584 "L"
4. Plate and Bearing P/N 391260
5. Rod P/N 326582
6. Installer/Remover, P/N 350958
7. 1/4-20 X 1 1/4 in. Hex head screw
IMPORTANT:
cannot be interchanged.
GEARCASE
Spacers are different sizes and
1
2
3
4
5
6
7
824182
1
2
3*
4
5
6
7
12
824182
329