Electric Starter Servicing; Removal; Disassembly - BRP Evinrude E-Tec Series Service Manual

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

ELECTRIC STARTER

Do not clean the starter drive

while the starter motor and drive are installed on

the powerhead. The cleaning agent could drain

into the starter motor, washing dirt from the drive

into the starter bearings and commutator.

Disconnect the battery cables at the battery.

Remove the starter positive (+) cable.

Remove the four frame and bracket mounting

screws. Remove the starter.

Loosen the two nuts used to fasten the starter

bracket. Remove the nuts and bracket.

ELECTRIC STARTER SERVICING

Remove the screws, lock washers, and pinion

Lift and remove the wave washer and bushing.

Place an appropriate-sized deep socket on the

ELECTRICAL AND IGNITION

Table of Contents